Wireless Access Point (WAP) equipment is powered by either Power over Ethernet (PoE) PD and DC-DC controllers or line driven AC/DC power supplies. Additional power management may be required to meet system operating needs and to protect from adverse power supply conditions. Kinetic Technologies offers industry-leading PoE power supply solutions, step-up and step-down DC-DC converters, RGB LED drivers, load switches, overvoltage switches with surge protection and ESD/EMI protection and suppression ICs to aid in system design.
Buck and Boost Converters
AC/DC line supplied converters and PoE PD and DC-DC controllers used in WAP applications do not always provide every voltage rail required by the system. Step-down and Step-up converters regulate the available voltage rails at the point of load to match system requirements.
For light-load current requirements, linear regulators can provide a compact, low-cost, step-down converter solution
For higher power applications, DC/DC switching regulators can be a better choice providing both step-up and step-down voltages at high efficiency.
WAP EMC compliance for Ethernet ports often presents a demanding design challenge, with PCB layout, component placement key to compliance. Kinetic Technologies’ EMI/ESD Suppression technology is unique in simplifying this task. The active ESD and EMI suppressor IC replaces large and costly passive components while improving the system robustness and reliability. Kinetic Technologies provides a 2 or 4-channel device in which each channel connects to one wire of the two twisted pair sets. ESD performance, EFT-B and surge immunity, and CM emissions equal or exceed passive techniques while occupying a much smaller footprint.
Kinetic Technologies’ EMI/ESD Suppression solution enables system designers to comply with:
CISPR22 and FCC Part 15, Class B requirements?for Radiated and Conducted Emissions
IEC 61000-4-3/6 requirements for Radiated and Conducted Immunity, Level 3 or higher
Quad Channel Active EMI & ESD Suppressor for Ethernet Applications
Overvoltage and Surge Protection ICs
WAP equipment often requires internal PoE DC-DC output or line supplied AC/DC converter voltage rails to be switched on/off to reduce standby or shutdown power consumption or to enable/disable specific circuit function while the device is in operation.
Integrated load switches provide simplified microcontroller I/O controlled power load switching, eliminating the need for bias and level shift circuits associated with discrete MOSFET switches
Load switches also provide slew-rate limited turn-on and shutdown mode reverse-current blocking?
Low RON Load Switch with Overvoltage and Reverse Blocking Protection
PoE PD Controllers
End products utilizing PoE typically requires high efficiency power conversion, in the smallest space with minimum component count. Kinetic Technologies offers a broad portfolio of product solutions that integrate the PD physical interface with a DC/DC controller function in a single package, supporting single outputs with power levels from a few watts up to 30W.
The AS11xx family support single output isolated or non-isolated solutions for IEEE802.3af (Type 1) and IEEE802.3at (Type 1 and Type 2) PDs or higher power levels, either by using custom programmed PSEs or by implementing the LLDP to enable 4-pair power delivery on the Ethernet cable. Some products include rectifier bridges for applications requiring space saving. All products include input and output over-current protection, output over-voltage protection, and over-temperature protection
13W/30W 802.3af/at PoE PD and Integrated DC-DC Controller
RGB LED Drivers
WAP equipment uses multicolor RGB LEDs as function indicator lamps. Indicator lamps show power on/off or function status. Implementing indicator lamp LED control circuits to interface LED control switching to microcontroller logic is a tedious design process and requires multiple discrete components.
RGB LED drivers allow simplified programmable control of LED color and brightness
3-channel RGB LED drivers permit custom color control
4-channel RGBW devices allow for driving a white LED in addition to the RGB LED
Multiple programming options include I2C or ExpressWire to ease integration with a wide variety of processors and operating systems
Wide range of ramp up/down timing for slow fade in/out effects and complex repeating patterns